Hitachi Power Tools

Hitachi: Inspire the Next

H65SD2 1-1/8 Inch Hex 40 lbs Demolition Hammer

  • 31 ft/lbs of impact energy
  • Powerful 10.8 Amp (1,240 W input) motor
  • Impressive impact rate of 1,400 bpm for rapid results
  • Low noise level, full-load only 104 dB
  • Low vibration levels (full-load vibration level of only 19.9 m/s2) for less fatigue with continuous use
  • Elastomer grip reduces vibration transfer while providing a secure hold for added safety
  • Cushioned auxilliary handle that rotates 360 degrees is located between the body of the tool and the bit cylinder to provide optimal control and grip on the tool
  • Universal tool retainer accepts 3 types of 1-1/8" hex shank bits; standard hex, collarless retaining groove and air tool bits
  • Hitachi's patented IDI (Internal Double Insulation) Technology significantly strengthens the body of the tool
  • Metal-seated armature bearing to reduce the effects of vibration and heat on motor performance
  • Auto-stop brushes prevent unnecessary maintenance issues
  • Lock-on trigger for comfortable extended use
  • Sealed lubrication to prevent grease from leaking out and dust from creeping in and damaging the internals
  • Impressive power to weight ratio for balanced and comfortable operation
  • Download the H65SD2 Tool Card


  • Plastic Rolling Case (333356)
  • 6mm Hex Bar Wrench (872422)
  • 3mm Hex Bar Wrench (943277)
Bit Type 1-1/8" Hex
Amps 10.8
Impact Energy 31 ft/lbs
BPM (full load) 1,400
Lubrication Sealed Grease
Power Input 1,240 W
Bit Types Collared or Slotted
Auto-Stop Brushes Yes
Low-Vibe Main Handle Yes
Vibration (full-load) 19.9 m/s2
Length 32-13/32"
Weight 40.8 lbs

Warranty Information


Find a Retailer

Related Tools

Related Image

DH40MR 1-9/16? SDS Max Shank Rotary Hammer, 2-Mode
The DH40MR SDS Max Rotary Hammer features a drilling speed that is 10% faster than similar products, while at the same time, produces lower vibration and noise levels than other tools in its class. With an increase in performance, operability and durability the DH40MR takes rotary hammers to a new level.

Related Image

CC12Y 12" Portable Cut-Off Saw, AC/DC
The CC12Y 12" Cut-off Saw cuts sheet metal, concrete, cinder blocks, bricks, reinforcing rods, concrete wire mesh, corrugated floor and ceiling forms.

Related Image

G18MR 7" 15-Amp Angle Grinder, AC/DC
The G18MR 7" Angle Grinder is equipped with Hitachi's IDI (Internal Double Insulation) technology that significantly strengthens the body of the tool.  The G18MR deburs diecast products and finishes iron, bronze, aluminum, welds and torch cut surfaces. It can also be used to cut soft steel materials as well as grooving and cutting concrete and other stone materials.